Here’s where you can configure the settings for the OUTPUT MODE, MIDI CH and the pedal that’s connected.
OUTPUT MODE
Here’s how to select how the effect sound is output.
Value |
Explanation |
---|---|
FIXED |
The same signal is output from the OUTPUT A (MONO) and OUTPUT B jacks. |
EFX/DIR |
The effect sound is output from the OUTPUT A (MONO) jack, and the direct sound is output from the OUTPUT B jack. When the effect is off, nothing is output from the OUTPUT A (MONO) jack. |
RANDOM |
Randomly outputs from the left, right and center positions. |
PING-PONG |
Alternately outputs from the left and right. |
AUTO |
The sound pans from left to right and then from right to left across the stereo field. |
3D CROSS |
The sound pans both back and forth and left-right across the stereo field. |
3D ROTATION |
Gives a three-dimensional feeling of rotation. |
MIDI CH
Here’s how to set the channel used for receiving MIDI messages from a MIDI device.
Value |
Explanation |
---|---|
1–10 |
1 ch–10 ch |
ALL | All channels |
CTL FUNCTION
Here’s how to assign functions to a footswitch that’s connected to this device.
Value |
Explanation |
---|---|
MOMENTARY/TAP |
Use this setting when connecting two footswitches or a dual footswitch externally. |
TAP TEMPO |
Assigns the tap tempo function. |
MOMENTARY |
Assigns the momentary switch (*) function for switching the effect on/off. |
- A “momentary switch” switches the effect on only while the footswitch is depressed.
EXP PEDAL FUNCTION
This sets the range of control for a connected expression pedal, which externally controls the knobs on the SL-2.
Value |
NIM |
MAX |
Explanation |
---|---|---|---|
DUTY |
0 |
127 |
Adjusts the minimum and maximum values for the ratio (sound length) with which the slice pattern sounds. |
ATTACK |
0 |
127 |
Adjusts the minimum and maximum values for the slice pattern’s attack waveform volume. |
TEMPO |
40 |
300 |
Sets the minimum and maximum values for the tempo. |
BALANCE |
0 |
127 |
Adjusts the minimum and maximum values for the balance between the effect sound and the direct sound. When this is “0”, only the effect sound is output; and when this is “127”, only the direct sound is output. |
OUTPUT LEVEL |
0 |
127 |
Sets the minimum and maximum values for the output volume of the OUTPUT A (MONO) and OUTPUT B jacks. |