Saving to a Memory

You can save the settings you’ve edited.

  1. Long-press the [MEMORY] button.
    The indicator of the currently selected memory number blinks, and the memory enters write standby mode.
  2. Take your finger off the [MEMORY] button.

  3. Press the [MEMORY] button to select where to save the memory.
    Each time you press the button, the memory selector cycles through as follows: MANUALÓ1Ó2Ó3Ó4.

    You can use an external MIDI device to select memories 5–127. When you select memories 5–127, the MEMORY 1–4 indicators all blink.
  4. Long-press the [MEMORY] button once more to save.

    The memory number indicators blink rapidly. Once they remain lit, the write operation is finished.
    When using an external MIDI device to select memories 5–127, the MEMORY 1–4 indicators all blink rapidly and then go dark.

  • If you operate the knobs or footswitch before step 3, the write operation is canceled.
  • If you’ve saved to MANUAL, only the [TAPE] button and expression pedal settings are saved.


Switching Memories

Here’s how to recall a saved memory.

  1. Press the [MEMORY] button or [MEMORY] switch to select the memory.
    Each time you press the button/switch, the memory selector cycles through as follows: MANUALÓ1Ó2Ó3Ó4.

    You can use an external MIDI device to select memories 5–127 via MIDI. When you select memories 5–127, the MEMORY 1–4 indicators all go dark.


What is “MANUAL”?

Normally, effects are applied according to the settings in memory. However, when you select MANUAL, effects are applied according to the position of the knobs on the panel. At this time, the TAP DIVISION and expression pedal settings that are recalled are those saved in MANUAL (which are editable).