It’s possible to turn on only the amp or cabinet.


  1. Turn off the power (unplug the cable from the INPUT jack).
  2. Set the type knob to “CLEAN”.

  3. Turn the [AMBIENCE], [LEVEL] and [GAIN] knobs all the way counterclockwise, and turn the [BASS], [MIDDLE] and [TREBLE] knobs all the way clockwise.


  4. While holding down the pedal switch, turn on the power by inserting a plug into the INPUT jack.

    After the CHECK indicator lights up green, it cycles between blinking orange once and staying lit.


  5. Use the type knob to select the settings.

    Type knob

    Explanation
    CLEAN

    AMP ON / CAB ON:

    Turns on both the amp and cabinet.

    • This is the factory setting.
    TWN

    AMP ON / CAB OFF:

    Turns on only the amp.

    Select this when you want to use an external cabinet simulator or the like.
    TWEED

    AMP OFF / CAB ON:

    Turns on only the cabinet.

    Select this when you want to use IR Loader by itself.



  6. Press the pedal switch.

    This saves the settings.

    Also, the CHECK indicator rapidly blinks red.

    You can play normally with this unit after around two to three seconds.