The RETURN jack on this unit is a stereo (TRS) jack.
When using the RETURN jack, change the setting (mono/stereo) to match the input signal.


  1. Turn off the power (unplug the cable from the INPUT jack).

  2. Set the type knob to “DIAMOND”.

  3. Turn the [AMBIENCE], [LEVEL] and [GAIN] knobs all the way counterclockwise, and turn the [BASS], [MIDDLE] and [TREBLE] knobs all the way clockwise.


  4. While holding down the pedal switch, turn on the power by inserting a plug into the INPUT jack.

    After the CHECK indicator lights up green, it cycles between blinking orange four times and staying lit.


  5. Use the type knob to select the input signal for RETURN.

    Type knob

    Explanation

    CLEAN

    MONO:

    Select this when you have connected a mono (TS) plug to input a mono signal.

    • This is the factory setting.

    TWN

    STEREO:

    Select this when you have connected a stereo (TRS) plug to input a stereo signal.



  6. Press the pedal switch.

    This saves the settings.

    Also, the CHECK indicator rapidly blinks red.

    You can play normally with this unit after around two to three seconds.