You can change the ambience type to the setting you like.


  1. Turn off the power (unplug the cable from the INPUT jack).

  2. Set the type knob to “TWN”.

  3. Turn the [AMBIENCE], [LEVEL] and [GAIN] knobs all the way counterclockwise, and turn the [BASS], [MIDDLE] and [TREBLE] knobs all the way clockwise.


  4. While holding down the pedal switch, turn on the power by inserting a plug into the INPUT jack.

    After the CHECK indicator lights up green, it cycles between blinking orange twice and staying lit.


  5. Use the type knob to select the ambience type.

    Type knob

    Explanation

    CLEAN

    ROOM:

    Simulates the reverberations of a small room. This offers a warm reverberation sound.

    • This is the factory setting.

    TWN

    HALL:

    Simulates the reverberations in a concert hall. This offers a milder reverberation sound.

    TWEED

    PLATE:

    Simulates plate reverb (a reverb unit with a metallic plate that vibrates to create reverb). Provides a metallic sound with a distinct upper range.



  6. Press the pedal switch.

    This saves the settings.

    Also, the CHECK indicator rapidly blinks red.

    You can play normally with this unit after around two to three seconds.