Here’s how to select how the effect sound is output.
- Turn the type knob to “SFX (8)”.
Turn the other knobs besides the type knob all the way clockwise.
While holding down the pedal switch, turn on the power by inserting a plug into the INPUT A (MONO) jack.
The CHECK indicator blinks orange.
Use the [VARIATION] knob to select how the effect sound is output.
[VARIATION] knob
Explanation
1
FIXED The same signal is output from the OUTPUT A (MONO) and OUTPUT B jacks.
When the effect is off, the direct sound is output from the OUTPUT A (MONO) and OUTPUT B jacks.
2
EFX/DIR The effect sound is output from the OUTPUT A (MONO) jack, and the direct sound is output from the OUTPUT B jack.
When the effect is off, nothing is output from the OUTPUT A (MONO) jack. The direct sound is output from the OUTPUT B jack.
3 *
RANDOM Randomly outputs from the left, right and center positions.
4 *
PING-PONG Alternately outputs from the left and right.
5 *
AUTO The sound pans smoothly from left to right and back again across the stereo field.
6 *
3D CROSS The sound pans both back and forth and left-right across the stereo field.
7 *
3D ROTATION Gives a three-dimensional feeling of rotation.
- You can get a stereo effect by setting the [VARIATION] knob between 3 and 7 and then using the OUTPUT A (MONO) and OUTPUT B jacks.
The settings are saved automatically whenever you turn the [VARIATION] knob.
When making the settings, you can hear the effect sound from the OUTPUT A (MONO) and OUTPUT B jacks.
Note that the sound that’s output uses the effect settings as they were just before the power on this device was last turned off.
If you’re hearing an effect sound that’s hard to distinguish, set the effect settings to simple settings (such as type knob = “SINGLE (1)”, [VARIATION] knob = “1” and so forth), turn off the device and start again from step 1.
Press the pedal switch.
The CHECK indicator rapidly blinks red.
The device can be used normally after around two to three seconds.