Error messages

Connection is Lost, please Disconnect!

The computer is no longer connected to the SP-404MK2.

1. Check whether the SP-404MK2 and your computer are properly connected with a USB cable, and try connecting again.
2. If this does not resolve the issue, restart both the SP-404MK2 App and the SP-404MK2.

Media Error.

The sample data could not be loaded.

• Only single-byte alphanumeric characters can be used for the file and folder names of the sample data. Check whether any characters that are not single-byte letters or numbers are being used.

• You cannot use sample data that’s longer than 16 minutes. Check whether the sample data you are trying to load is too long or too short.

Error.

An error occurred when trying to open the file or folder.

Do not unplug or plug in a USB cable connecting the SP-404MK2 to your computer while you’re using the app.

1. Check whether the SP-404MK2 and your computer are properly connected with a USB cable, and try connecting again.
2. If this does not resolve the issue, restart both the SP-404MK2 App and the SP-404MK2.

If the above methods do not resolve the issue, the file or folder you’re trying to load or save might be corrupted, or the file or folder name might contain characters other than single-byte letters or numbers. Check whether the data has been correctly saved.

Not Found.

Open Error.

Read Error.

An error occurred when reading the file.

Write Error.

An error occurred when writing the file.

Media Full Error.

The SP-404MK2 has run out of free space.

Delete any data you don’t need on the SP-404MK2 to increase the amount of free storage capacity.

BPM Detect Error.

The BPM could not be analyzed.

Try inputting the BPM manually.

Protected!

The function can’t be executed because bank protect is enabled.