Using the Looper in Sync with External Device Clocks

Recording audio input

1. Press the [â/ó] (play/record) button.

   The unit enters record standby mode, and “rEC” blinks in the display.
   Recording starts when the next clock is inputted.
   During recording or overdubbing, “rEC” is displayed and the [â/ó] (play/record)  button lights up red.

   
   

2. To finish the recording, press the [â/ó] (play/record) button again.

   “PLAY” blinks in the display and the unit enters record stop mode.
   Recording stops when the next clock is inputted, and playback automatically begins.
   During playback,  “PLAY” is displayed, and the [â/ó] (play/record)  button lights up green.

   
   

Stopping audio that’s playing back (or switching to standby)

1. Press the [ð] (stop) button during playback.

   The display indicates “STOP”, and playback stops when the next clock is inputted.

   
   

Playing back recorded audio

1. Record once, and then stop recording.

2. Press the [â/ó] (play/record) button when playback or recording is stopped.

   Playback starts when the next clock is inputted.
   During playing back, the [â/ó] (play/record) button blinks green and “PLAY” is displayed.

   
   

How the looper’s state changes with the synchronization type

The sync works differently depending on how the external device is connected.
See the information below for how sync works differently when you press the buttons.