EFX SET

Routing

TYPE A, TYPE B

Selects the routing (connection) of the bus to which effects are assigned.

“Configuring the Effect Routing”

FAVORITE

1–16

Selects the combination of effects assigned to BUS 3 and BUS 4.

“Changing the Effects Assigned to BUS 3 and BUS 4”

EFX TYPE

Bypass, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Downer, Compressor, Equalizer, Isolator, Super Filter, Filter+Drive, WrmSaturator, Overdrive, Distortion, Crusher, Ring Mod, SBF, Resonator, Hyper-Reso, Chromatic PS, Reverb, Ha-Dou, Zan-Zou, Sync Delay, TimeCtrlDly, Ko-Da-Ma, Tape Echo, Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan, To-Gu-Ro, DJFX Looper, Scatter

Selects the effects assigned to BUS 3 or BUS 4.

For details on the parameters of each effect, refer to “MFX List”.

Direct FX1–Direct FX5

Filter+Drive, Resonator, Sync Delay, Isolator, DJFX Looper, Scatter, Downer, Ha-Dou, Ko-Da-Ma, Zan-Zou, To-Gu-Ro, SBF, Stopper, Tape Echo, TimeCtrlDly, Super Filter, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Reverb, Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan, Chromatic PS, Hyper-Reso, Ring Mod, Crusher, Overdrive, Distortion, Equalizer, Compressor

You can assign the effects you like to the effect buttons on the top panel.

For details on the parameters of each effect, refer to “MFX List”.

Mute Bus

This individually selects the bus to mute with MUTE BUS.

ALL

Both BUS 1 and BUS 2 are muted.

BUS

Only the bus selected with the [BUS FX] button is muted.

Input FX

Bypass, Auto Pitch (*), Vocoder (*), Gt Amp Sim (*), Harmony (*), Chorus, JUNO Chorus, Reverb, TimeCtrlDly, Chromatic PS, Downer, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Equalizer, Compressor

Effects marked with an (*) are for INPUT FX only.

You can apply effects to the audio that’s inputted to this unit.

For details on the parameters of each effect, refer to “MFX List”.

Input Bus

You can set the bus to which the playback audio signals coming into the INPUT jack are sent (meaning which effects are used).

DRY

The signal is not sent to BUS 1, BUS 2 (the BUS 1 and BUS 2 effects are not used).

BUS1, BUS2

The signal is sent to BUS 1 or BUS 2. The effects set for BUS 1 and BUS 2 are used.

This sets the routing for audio sent to the DRY bus.

DRY

Audio is not sent through BUS 1–BUS 4 (no effects are applied).

BUS3

Audio is inserted just before BUS 3. The BUS 3 and BUS 4 effects are applied.