Configuring the metronome

Here’s how to change how the metronome plays and its volume.

  1. Hold down the [SHIFT] button and press pad [15] (MENU).

  2. Use the [TEMPO/VALUE] knob to select the parameters below, and then press pad [2] (ENTER).

    Parameter

    Value

    Explanation

    Ntro
     (Metronome)

    OFF

    Always off

    rEC (Rec)

    Turns on only when recording

    rC.PL (Rec&Play)

    Turns on during recording and playback
    Ntr.L
    (Metronome Level)    		 0–100 Sets the volume of the metronome.


Setting the length (the number of beats) of the count-in

Here’s how to set the length (the number of beats) of the count-in for recording.

  1. Hold down the [SHIFT] button and press pad [15] (MENU).

  2. Use the [TEMPO/VALUE] knob to select “Cnt.I”, and press pad [2] (ENTER).

    Parameter

    Value

    Explanation
    Cnt.I
    (Count In)    		 OFF, 2–4 Sets the length (the number of beats) of the count-in for recording.
    • The metronome or count-in click plays in quarter-note intervals.
    • The metronome timing is reset at the beginning of the pattern. (Ver. 1.02)