Hold down the [SHIFT] button and press the [D-MOTION] button.
The settings screen is shown in the display.
Use the [TEMPO/VALUE] knob to select a parameter, and then press pad [2] (ENTER).
Turn the [TEMPO/VALUE] knob to edit the value.
Configure the parameters that you want to change when you tilt this unit from left to right (roll), or when you tilt the unit forward and backward (pitch).
roLL (Roll)
OFF: No parameters are changed.
Nod (Modulation): A cyclical change is applied to the pitch or filter according to how the unit is tilted, just like when MIDI modulation data is received. (The effect is the same for both positive and negative directions.) Adjust the effect speed with the LFO [RATE] knob, and the depth with LFO Modulation Depth.
FrEq (Frequency): Raises or lowers the cutoff point centered on the current value of the [FREQ] knob, according to the tilt of this unit.
rESo (Resonance): Emphasizes or dampens the frequencies around the cutoff point according to the tilt of this unit, centered on the current value of the [RESO] knob.
P.bnd (Pitch Bend): Tilting this unit applies pitch bend changes to the pitch or to the filter according to how this unit is tilted, just like when MIDI pitch bend data is received. Use Oscillator Bend Sens or Filter Bend Sens to adjust the effect depth.
PAn (Pan): Changes the left-right stereo position of the sound according to how this unit is tilted, just like when MIDI pan data is received.
EXP (Expression): Changes the volume according to how this unit is tilted (only in the negative direction), just like when MIDI expression data is received.
d.LEv (Delay Level): Changes the delay volume according to how this unit is tilted, centered on the current value of the DELAY knob.
r.LEv (Reverb Level): Changes the reverb volume according to how this unit is tilted, centered on the current value of the REVERB knob.Ptch (Pitch)