With these settings, you can set how the sequencer operates, and access useful functions (utilities) for input.

  1. While in sequencer mode, press the [COMMON] button.

    The sequencer menu appears.


  2. Use the [VALUE] knob to select the item, and press the [VALUE] knob.

    The setting for the item you selected is shown.


  3. Turn the [VALUE] knob to set the value, and press the [VALUE] knob.

    This confirms the value you set.


  4. When you are finished making the settings, press the [EXIT] button.



Step buttons Indication Value Explanation
[1] SHFL

-90–90

Sets the timing at which the upbeats (even-numbered steps) play.
[2] SCAL

8, 16, 32, 4t, 8t, 16t

“About note values”

 Specifies the length (scale) of one note for each step.
[3]

S.LEn

1–64

Sets the length (number of steps) of the pattern.
[4] dir Specifies how the sequencer plays.
FľD

Plays forward from the first step.
REV

Plays backward from the last step.
F_R Plays forward from the first step, and plays backward after reaching the last step.
InV Inverts and plays back the even-numbered and odd-numbered steps.
rnd

Plays steps randomly.
k.trg The sequence plays back normally while you are playing the keyboard.
[5] CC

OFF, On

When this is on, the unit outputs a control change message whenever you change the patch’s settings (when you operate the controls on the panel).
[6] dUPL
Doubles the number of steps in a pattern and copies the performance data.
[7] rnd
Generates random performance data.
[8] Undo
Reverts the performance data settings to their most recent state just before being edited.
[9] rEdo
Restores the performance data settings to the state they were in before the last undo operation (in other words, this cancels the undo).
[10] COPY

Copies the performance data.
[11] PStE
Pastes the performance data you copied.
[12] C.CLr
Deletes the control change messages from a pattern.
[13] n.CLr
Deletes the note messages from a pattern.
[14] A.CLr
Deletes the control change and note messages from a pattern.



You can also press a corresponding step button to select the parameter items.