Adds cyclical change (a swelling effect) to the sound.
| Controller (Parameter) | Value | Explanation |
|---|---|---|
| [LFO SELECT] button | LFO 1, LFO 2 | Selects the LFO to operate. |
| [RATE] slider | 0–100 |
Sets the speed of the LFO cycle. |
| [DELAY] slider | 0–100, REL | Sets the time it takes before the LFO effect begins after you press a key. The larger the value, the longer it takes for the LFO effect to start after you play the keyboard. By setting the value to REL, the LFO takes effect after you take your hands off the keyboard. |
| [FADE] slider | -50–50 | Sets the time-based change of the LFO as it takes effect. Positive values make the LFO amplitude increase gradually. The larger the value, the longer it takes for the amplitude to reach maximum. Negative values make the LFO amplitude decrease gradually. The smaller the value, the longer it takes for the amplitude to reach minimum. No time-based change occurs when this is set to “0”. |
| [WAVEFORM] button | Selects the LFO waveform. | |
| TRi (đ) | Triangle wave | |
|
SAľ ( |
Sawtooth wave | |
| SQr (ē) | Square wave | |
| S_H (ĕ) | Sample & hold | |
|
RnD ( |
Random | |
| [OFFSET] button | -, 0, + | Shifts the LFO waveform up or down. You can shift the waveform up or down in respect to the base pitch or cutoff frequency (value). |
| [KEY TRIG] button | This sets the timings for when you play the keyboard and when the LFO cycle starts. | |
| OFF | The timing of the LFO cycle is not affected by when you play the keys (no synchronization occurs). | |
| ON | The timing of the LFO cycle is synchronized with when you play the keys. | |
)
)