Here’s how to assign the built-in effects of this unit to BUS 1 or BUS 2. You can use two types of effects separately.

  1. Press the [BUS FX] button to select the bus to configure.
    When the button is lit orange, BUS 1 is selected; and when the button is blinking orange, BUS 2 is selected.
  2. Press the [FILTER+DRIVE]–[MFX] buttons to select the effect to assign to the bus.


You can assign the built-in effects of this unit to BUS 3 or BUS 4. Up to four effects are available.

To assign an effect to BUS 3 or BUS 4, change the settings in the effect setting screen.

→ “Configuring the Effect Settings (EFX SET)”