SYSTEM

This sets how the values change when you move the knobs.

When you move a knob, control data is only outputted when the position of the knob reaches or “catches up” to the value of its internal parameter.

• In “Mixing the Samples (DJ MODE),” the knobs work in CATCH mode, regardless of the settings.

When you move a knob, the control data (current position) is always outputted.

EFX Knob Mode

This sets how the values change when you move the knobs.

When you move a knob, control data is only outputted when the position of the knob reaches or “catches up” to the value of its internal parameter.

When you switch effects, control data corresponding to the position of the knob is outputted.

This sets the project that loads when the unit starts up.

Loads the project that was used right before the power was last turned off.

Loads a specified project.

This sets the functionality of the [SUB PAD] button in sample mode.

Retriggers the current pad (plays its sound again).

Switches to skip-back mode.

Sets the level at which note input is detected (the level at which sampling automatically starts, and the level at which recording to the skip-back memory begins).

Sets the time before the screen saver starts (in minutes).

Scrn Saver Type

OldRave, Naminori, Custom

Selects the type of screen saver.

When you select “Custom,” you can use an image file that you’ve imported as the screen image for the screen saver (Customizing the Screen Saver).

Sets the brightness of the buttons.

Adjusts the brightness when the button lights are dim.

When this is set to “ON,” the tempo (BPM) is automatically detected when you import a sample.

Selects the range at which the tempo (BPM) of a sample is automatically detected.

When this is set to ON, the metronome sound is output from the LINE OUT jacks and from the USB port.

Sets the volume of the metronome.

When this is ON, the metronome sound is output while you are sampling or resampling.

When this is ON, the metronome sound is output when a pattern is being recorded.

This selects how sampling or resampling starts.

When you press the [REC] button, a count-in begins one or two measures before where sampling or resampling begins.

This selects how pattern recording begins.

1 MEAS, 2 MEAS

When you press the [REC] button, a count-in of one or two measures begins before pattern recording starts.

WAIT

Specifies the tempo source.

When this is ON, clocks, start and stop are transmitted to the device connected to this unit’s MIDI OUT connector.

If this is ON, MIDI messages that are inputted to the MIDI IN connector are re-transmitted without change from the MIDI OUT connector.

When this is ON, MIDI signals that are inputted via the USB port are outputted to the MIDI OUT connector. MIDI signals that are inputted via the MIDI IN connector are also outputted to the USB port.

The inputted MIDI signals are also transmitted to the internal sound module at the same time.