These parameters configure the overall settings for the parts.
| Step buttons | Parameter (as displayed) | Value | Explanation |
|---|---|---|---|
| [1] | UoL | 0–127 | Adjusts the part volume. You can adjust this parameter for each pattern. |
| [2] | PAn | L 64–r 63 | Sets the pan position for each part. |
| [3] | F.typ | 1, 2, 3 | Sets the change characteristics, modeled after an classic analog synthesizer LPF (low-pass filter). |
| [4] | Cndi | 0–100 | Adds a deteriorated effect to the sound. |
| [5] | EHP | OFF, On | When this is on, the amount of change made by the LFO RATE, VCO CUTOFF FREQ, VCF RES and VCF ENV is expanded (increased) beyond that of the original model. |
| [6] | P.UEL | 0–3 | Adjusts how much the effect changes the pitch envelope according to how hard you press the keys (velocity). |
| [7] | A.UEL | 0–3 | Adjusts how much the effect changes the VCA envelope according to how hard you press the keys (velocity). |
| [8] | F.UEL | 0–3 | Adjusts how much the effect changes the VCF envelope according to how hard you press the keys (velocity). |
| [9] | N.UEL | 0–3 | Adjusts how much the effect changes the MIXER envelope according to how hard you press the keys (velocity). |
| [10] | bEnd | 2, 3, 4, 7 (semitones) | Sets the variable pitch range for the pitch bend. |
| [11] | N.Lfo | -63–63 | Adjusts the depth of the modulation effect. |
| [12] | P.crU | This sets the curve used by the portamento effect to change the pitch. | |
| orG | The same curve of change used on the original model is applied. | ||
| LinE | A linear curve of change is applied. | ||
| E.1 | A non-linear curve (gradual slope) of change is applied. | ||
| E.2 | A non-linear curve (steep slope) of change is applied. | ||
| [13] | AF.LF | -63–63 | Adjusts how much the LFO is changed by aftertouch (only enabled when a product featuring aftertouch is connected). |
| [14] | AF.Fq | -63–63 | Adjusts how much the low-pass filter (LPF) is changed by aftertouch (only enabled when a product featuring aftertouch is connected). |
| [15] | AF.LU | -63–63 | Adjusts how much the tone is changed by aftertouch (only enabled when a product featuring aftertouch is connected). |
|
You can also press a corresponding step button to select the parameter items. |
