This section is used to select the waveforms that determine the character of the sound, and to set the pitch.


Controller (Parameter) Value Explanation
[LFO] slider 0–10 Sets how much LFO modulation is applied to DCO-1 and DCO-2.

[TUNE] knob

 -1OCT–+1OCT Shifts the pitch in units of a semitone.
[FINE TUNE] knob -–+ Finely adjusts the pitch.
[RANGE] switch 2' ,4' ,8' ,16' Sets the octave for DCO-1 and DCO-2.
[WAVEFORM] knob This knob sets the waveform.

Sawtooth wave

Pulse wave
ē Square wave

Noise
[CROSS MOD] switch This selects the mode in which the modulation operates.

X-MOD

The DCO-1 and DCO-2 interact to generate the pitch, harmonic components and output waveform.

SYNC

Synchronizes the oscillators. This creates a complex waveform by forcibly restarting DCO-2 so that it syncs with the cycle of DCO-1.

OFF

DCO-1 and DCO-2 each generate their own pitches and waveforms.

[DCO-1 ENV] knob

[DCO-2 ENV] knob

 0–10 Adjusts how much the envelope selected with the MODE switch is used to modulate DCO-1 and DCO-2.
[MODE] switch

1 (NORMAL),

1 (INVERSE),

2 (NORMAL),

2 (INVERSE)

Selects the envelope and polarity that controls the DCO.