When Feedback Mode is “norN” (NORMAL)


When Feedback Mode is “CroS” (CROSS)

 

Step buttons Parameter Value Explanation
[1] tyPe dLy3

Adds a wavering feel to the delay sound.
[2] Sľ Off, On Turns the effects on/off.
[3] L.Snc Off, On

When this is ON, the effect synchronizes with the tempo of the rhythm.

“Tempo Settings”
[4] L.tiN 1–1300  (ms)

Time from when the direct sound of the left channel is heard until the delay sound is heard
[5] L.not

“About note values”
[6] R.Snc Off, On

When this is ON, the effect synchronizes with the tempo of the rhythm.

“Tempo Settings”
[7] R.tiN 1–1300  (ms)

Time from when the direct sound of the right channel is heard until the delay sound is heard
[8] R.not

“About note values”
[9] FB.Nd norN, CroS The input where the delay sound is returned (see the algorithm diagram)
[10] Fb -98–98  (%) Adjusts the proportion of the delay sound that is fed back into the effect. (Negative values invert the phase.)
[11] H.dNP 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000  (Hz), byPS

Center frequency at which the high frequencies of the delay sound fed back to the input are cut

(byPS: does not cut the frequencies)
[12] Nod

These parameters configure the modulation.

 

Step buttons Parameter Value Explanation
[1] rAT.S OFF, On

When this is ON, the effect synchronizes with the tempo of the rhythm.

“Tempo Settings”
[2] rAT.H 0.05–10.00  (Hz) Modulation cycle
[3] rAT.n

“About note values”
[4] dEPt 0–127 Modulation depth
[5] PHS 0–180  (deg) Modulation width


[13] Eq.Lo -15–15  (dB) Amount of low range boost/cut
[14] Eq.Hi -15–15  (dB) Amount of high range boost/cut
[15] bAL

Volume balance between the effect sound and dry (original) sound

0

Effect sound : Dry sound = 0 : 100
100 Effect sound : Dry sound = 100 : 0
[16] LEU 0–127 Output level


You can also press a step button to select the parameter items.