Step buttons Parameter Value Explanation
[1] tyPe Ptc2

Shifts the pitch of the dry sound. You can layer two pitch-shifted sounds onto the dry sound.
[2] Sľ Off, On Turns the effects on/off.
[3] 1.CrS

-24–12 (semitones)

 Amount of pitch shift applied for pitch-shift 1 (in semitones)
[4] 1.Fin

-100–100 (cent)

 Amount of pitch shift applied for pitch-shift 1 (in units of two cents)
[5] 1.dÆy

These are the settings for the pitch-shift 1 delay and feedback parameters.

Step buttons Parameter Value Explanation
[1] Sync OFF, On

When this is ON, the effect synchronizes with the tempo of the rhythm.

“Tempo Settings”
[2] tiNE 1–1300 Time from when the dry sound is heard until the pitch-shifted sound is heard
[3] notE

“About note values”
[4] Fb

-98–98 (%)

 Adjusts the proportion of the pitch-shifted sound that is fed back into the effect. (Negative values invert the phase.)


[6]

1.PAn

 L 64–R 63 Panning for pitch-shift 1 sound
[7] 1.LEU 0–127 Pitch-shift 1 volume
[8] 2.CrS

-24–12 (semitones)

Amount of pitch shift applied for pitch-shift 2 (in semitones)
[9] 2.Fin

-100–100 (cent)

Amount of pitch shift applied for pitch-shift 2 (in units of two cents)
[10] 2.dÆy

These are the settings for the pitch-shift 2 delay and feedback parameters.

Step buttons Parameter Value Explanation
[1] Sync OFF, On

When this is ON, the effect synchronizes with the tempo of the rhythm.

“Tempo Settings”
[2] tiNE 1–1300 Time from when the dry sound is heard until the pitch-shifted sound is heard
[3] notE

“About note values”
[4] Fb

-98–98 (%)

 Adjusts the proportion of the pitch-shifted sound that is fed back into the effect. (Negative values invert the phase.)


[11] 2.PAn L 64–R 63

Panning for pitch-shift 2 sound
[12] 2.LEU 0–127 Pitch-shift 2 volume
[13] EQ.Lo

-15–15 (dB)

 Amount of low range boost/cut
[14] EQ.Hi -15–15 (dB) Amount of high range boost/cut
[15] bAL

Volume balance between the effect sound and dry (original) sound
0

Effect sound : Dry sound = 0 : 100
100

Effect sound : Dry sound = 100 : 0
[16] LEU 0–127 Output level



You can also press a step button to select the parameter items.