Configuring the audio

Here’s how to configure the settings related to audio streaming, as well as the mic-related settings for the GO:PODCAST.

Tap the respective icon to edit the settings.

General audio settings

Item	Explanation
Delay	If there is a timing discrepancy between the video and audio, you can correct the output timing by delaying the audio output.
	Auto	Auto mode: This measures the delay time of the video transmitted from the satellite camera, and uses the measured value as the delay time. After launching the GO:PODCAST app, the video from the first satellite camera that was connected is used for measurement. If a satellite camera is not connected, the delay time is set to “0.0 sec”. This function is only possible with the iOS app.
	Manual	Manual mode: Manually adjusts the latency. Select “Manual”, tap “Delay Value” (the slider icon), which is shown when “Manual” is selected, and then use the slider to adjust the latency. This function is only possible with the iOS app.
	Delay Value	Sets the latency time for the output audio when “Manual” is selected on the iOS app, or when you’re using the Android app.
Output Mute	Controls the muting of the output audio. This works in tandem with the “Output Mute” button on the main screen.
System Volume	Adjusts the smartphone volume. You can also operate this using the smartphone’s volume adjustment buttons. Set the System Volume to maximum. When the System Volume is reduced, the sound of background music and so on that’s output from the PHONES jack of the GO:PODCAST is also lowered. The System Volume settings have no effect on the audio that’s livestreamed or recorded for video.

GO:PODCAST mic settings

Item	Explanation
Device Name	Shows the connected audio devices. If the GO:PODCAST does not appear and the message “Not Found” is shown, the app cannot recognize the USB mic. Check the connection between the GO:PODCAST and your smartphone.
Mic Mute	Controls the muting of the GO:PODCAST.
Mic Gain	Sets the mic gain of the GO:PODCAST.
Phones Volume	Sets the volume of audio output to headphones from the GO:PODCAST.
Reverb	Adds reverb (acoustic reverberations) to the audio input from the GO:PODCAST. This setting is only available for streamed/recorded audio.
Polar Pattern	Changes the directivity of the GO:PODCAST mic.
	Cardioid	Single direction mode. Audio is picked up only from directly in front of the mic.
	Omnidirectional	Omnidirectional mode. The mic picks up audio from all directions, including the rear.
	Stereo	Stereo mode. Audio is picked up from the left and right sides (in stereo), with the front of the mic as the center. The audio is transmitted to the smartphone or computer as a stereo audio signal.
	Switched Stereo	Inverted stereo mode. Works like stereo mode, but the left and right channels are switched. If the camera video and left-right audio do not match up, switch the mode.