You can remove the faceplate of this unit to customize the top panel.
  • Make sure you don’t cut your fingers on the edges when removing or attaching the faceplate.
  • The faceplate may bend if it is exposed to strong impact when removed. If this happens, you may not be able to reattach it.


Removing the faceplate

  1. Use a commercially available hex wrench (2 mm) to remove the two screws (at the front of the unit) circled in blue.

  2. Remove the screws (at the far side of the unit) circled in red.


Attaching the faceplate

To attach the faceplate, follow the steps for removing the top panel in reverse order.

  1. Use a commercially available hex wrench (2 mm) to attach the two screws (at the far side of the unit) circled in red.

  2. Install the two screws (at the front of the unit) circled in blue.
    Overtightening the screws may damage the screw holes.