You can edit the samples that are used in DJ mode.

  1. Press the [VALUE] knob.

    A menu appears.

  2. Use the [VALUE] knob to select “CH1 EDIT” or “CH2 EDIT,” and press the [VALUE] knob.

    The sample edit screen appears. The editing method is the same as for sample edit in sample mode.

    Controller Action

    [CTRL 1] knob

    Moves the start point.

    [CTRL 2] knob (when the loop is on)

    Moves the loop point.

    [CTRL 3] knob

    Moves the end point.

    [SHIFT] button + [CTRL] knob (turn)

    Zooms the area around each point in/out.

    [VALUE] knob (turn)

    Zooms the area in/out around each point you just manipulated.

    [VALUE] knob (press)

    You can use a numerical value to set the position of each point.

    Use the [VALUE] knob to select the point to set, and press pads [1]–[10] to input the position (press pad [10] to input a “0”).

    To confirm the inputted position, press the [VALUE] knob.

    [SHIFT] button + [VALUE] knob (turn)

    Adjusts the volume of the channel.

    [DEL] button

    Initializes the start and end point positions.

    • When a confirmation message appears, use the [VALUE] knob to select “OK,” and press the [VALUE] knob.

    [REMAIN] button

    On: Prevents the start point from being moved beyond the loop point or the end point.

    Off: When the start point moves beyond the loop point or the end point, this moves the loop point or the end point as well.

    [ROLL] button

    While this button is pressed, you can preview the sound several seconds before the end point.