Splits the sample at the marker positions, and assigns the resulting samples to separate pads.

  1. Follow the steps in “Marking and Splitting Samples (MARK)” to add a marker where you want to split the sample.

  2. Press the [VALUE] knob.

    A menu appears.

  3. Use the [VALUE] knob to select “ASSIGN TO PAD”, and press the [VALUE] knob.

    The assign screen appears.

  4. Set the parameters.

    Controller Explanation

    Pads [1]–[16]

    Selects the pads [1]–[16] to which you want to assign the split samples.

    • The empty pads to which samples haven’t been assigned blink yellow.
      When you press the empty pad to which you want to assign the sample, it lights up green.
    • Pads to which samples have already been assigned light up dark orange.
      If you press a pad for which a sample is already assigned, the pad lights up red. The assigned sample is then overwritten.
    [CTRL 2] knob

    Selects the marker where the sample is to be split.

    [CTRL 3] knob

    Turns the GATE on/off.
    Turn the [VALUE] knob

    Arranges the split samples in order, with the first pad number being the one you selected using the [VALUE] knob. Press the [MARK] button to confirm the arrangement.

    • This operation only confirms the pads to which the samples are to be assigned, without actually assigning the samples. To assign a sample to a pad, you must press the [VALUE] knob last.
    • Before pressing the [MARK] button, you can switch the pad bank and change the pad bank to which the sample is assigned.

    [MARK] button

    [DEL] button

    Cancels the assignment of the sample you selected with the [CTRL 2] knob.

  5. Press the [VALUE] knob.

    The split samples are assigned to the pads.