You can create a pattern using only specific samples that were taken from a pattern that you’ve inputted using multiple samples.

  1. Following the steps in “Copying the Pattern of a Pad”, press the source pattern (pad) and then the save destination pattern (pad).

    If you decide to cancel, press the [EXIT] button.
    • If you use the bank [A/F]–[E/J] buttons to select the bank before pressing the pads, you can save the pattern to a different bank.
    • You can use the [CTRL 3] knob to select a project, when saving the pattern to a different project.

  2. Press the [REMAIN] button.

    Samples (pads) that are used by a pattern light up dimly in white.

  3. Press the samples (pads) that you want to extract.

    The pads light up white.

  4. Press the [REMAIN] button.

  5. Press the [VALUE] knob or [COPY] button.

    The pattern for which only the selected samples are enabled is saved to the specified pad.

    Performing this operation overwrites (erases) the pattern in the copy destination pad.