Shortcuts used in DJ mode

[SHIFT] button + [REVERSE] button + pad [13] (CH1)

[SHIFT] button + [REVERSE] button + pad [15] (CH2)

MUTE

Mutes the sample that’s playing back.

[SHIFT] button + pads [1]–[16]

–

You can play back a sample from the position of the marker that’s set for that sample.

[SHIFT] button + [REMAIN] button

–

The [SHIFT] button remains in a “pressed-down” state. This makes it easier to select a marker and play back.

Press the [EXIT] button to cancel this behavior.

[SHIFT] button + [MARK] button

–

You can add markers while playing samples in DJ mode.

[SHIFT] button + [START/END] button

–

You can edit markers while playing samples in DJ mode.

[SHIFT] button + [DEL] button + pads [1]–[16]

–

While in DJ mode, you can delete the markers you’ve set for samples.

[SHIFT] button + [ROLL] button

ROLL SIZE

Sets the roll interval (1/4, 1/2, 1 or 2 measures).

Set the ROLL SIZE before playing back rolls. (You can’t change the ROLL SIZE with this operation while a roll is playing back).

[ROLL] button + pad [13] (CH1)

[ROLL] button + pad [15] (CH2)

–

Repeats the sample playback in more detailed intervals (ROLL).

Note that when the ROLL SIZE (roll interval) is longer than the sample length, a roll cannot played back.

–

Changes the roll interval while the roll is playing back.

[ROLL] button + pad [1]: quarter-note (1/4 of a measure)

[ROLL] button + pad [2]: half-note (1/2 of a measure)

[ROLL] button + pad [3]: whole note (1 measure)

[ROLL] button + pad [4]: two whole notes (2 measures)

[REMAIN] + pad [14] (CH1)

[REMAIN] + pad [16] (CH2)

BUS FX

You can set the bus to which the CH1/CH2 sample playback is sent (meaning which effects are used).

While holding down the [REMAIN] button, each time you press pad [14] or pad [16] switches the effect to use as follows: “BUS-1” -> “BUS-2” -> “DRY” -> “BUS-1”.

Press [RESAMPLE] button + [VALUE] knob

VOLUME CURVE

Selects the volume curve characteristics used for each slider (CH1 LEVEL, CH2 LEVEL, X-FADE) in DJ mode.

Each time you hold down the [RESAMPLE] button and press the [VALUE] knob, the characteristic switches in this order: “FAST CUT” -> “LINEAR” -> “SQUARE” -> “CUBIC” -> “FAST CUT”.

[DEL] button + pad [2] + pad [6] (CH1)

[DEL] button + pad [4] + pad [8] (CH2)

BPM

Resets the tempo to the default value.

[START/END] button

–

Switches between the functions (CUE MIX or X-FADE) for the [CTRL 3] knob.

[PITCH/SPEED] button

–

Changes the number of digits shown for the BPM.

Each time you press the [PITCH/SPEED] button, the display switches in the following order: integers only -> to the second decimal place -> to the first decimal place -> integers only....

When you set the BPM value using pads [2] [4] (BPM+) and pads [6] [8] (BPM-), the number of digits shown for the BPM changes according to the minimum unit.

[MARK] button

–

Switches between the EFX and MIXER screen views.

[BPM SYNC] button

–

Selects the channel (CH1/CH2) used to control reverse playback ([REVERSE] button).