Chain Palette

This is a chorus effect for bass.

Parameter Value Explanation
ON/OFF OFF, ON Turns this effect on/off.
TYPE

MONO

 This chorus effect outputs the same sound from both L channel and R channel.

STEREO

 This is a stereo chorus effect that adds different chorus sounds to L channel and R channel.
RATE 0–100, BPM ŀ–Ō

Adjusts the rate of the chorus effect.

  • When set to BPM, the value of each parameter will be set according to the value of the “MASTER BPM” specified for each memory. This makes it easier to achieve effect sound settings that match the tempo of the song.
  • If, due to the tempo, the time is longer than the range of allowable settings, it is then synchronized to a period either 1/2 or 1/4 of that time.
DEPTH 0–100 Adjusts the depth of the chorus effect. To use this as a doubling effect, set this to “0”.
EFFECT LEVEL 0–100 Adjusts the volume of the effect sound.
LOW CUT

FLAT, 20.0 Hz–12.5 kHz

 Sets the frequency at which the low cut filter begins to take effect. When “FLAT” is selected, the low cut filter has no effect.
HIGH CUT

20.0 Hz–12.5 kHz, FLAT

 Sets the frequency at which the high cut filter begins to take effect. When ”FLAT” is selected, the high cut filter has no effect.
DIRECT LEVEL 0–100

Adjusts the volume of the direct sound.

Setting this to “0” cuts the direct sound.
BPM 40–250

Adjusts the BPM value for each memory.

  • BPM (beats per minute) indicates the number of quarter note beats that occur each minute.
  • When you have an external MIDI device connected, the MASTER BPM synchronizes to the external MIDI devices tempo, making it impossible to set the MASTER BPM. To enable setting of the MASTER BPM, set “SYNC CLOCK” to “INTERNAL”.