Chain Palette

A reverb that you can set in greater detail than the standard reverb effect.

Parameter Value Explanation
ON/OFF OFF, ON Turns this effect on/off.
TYPE





 HALL S Simulates the reverberation in a concert hall. Provides clear and spacious reverberations.
HALL M Simulates the reverberation in a concert hall. Provides mild reverberations.
PLATE Simulates plate reverberation (a reverb unit that uses the vibration of a metallic plate). Provides a metallic sound with a distinct upper range.
ROOM S Simulates the reverberation in a small room. Provides warm reverberations.
ROOM L Simulates the reverberation of a room larger than ROOM S.
AMBIENCE Simulates an ambience mic (off-mic, placed at a distance from the sound source) used in recording and other applications. Rather than emphasizing the reverberation, this reverb is used to produce a sense of openness and depth.
SPRING This simulates the sound of a guitar amp’s built-in spring reverb.
TIME 0.1 s–10.0 s Adjusts the length (time) of reverberation.
TONE -50–0–+50 Adjusts the tonal character of the reverb.
EFFECT LEVEL 0–100 Adjusts the volume of the reverb sound.
DENSITY 1–10 Adjusts the density of the reverb sound.
PRE-DELAY 0ms–200ms Adjusts the time until the reverb sound starts to output.
LOW CUT

FLAT, 20.0 Hz–12.5 kHz

 Sets the frequency at which the low cut filter begins to take effect. When “FLAT” is selected, the low cut filter has no effect.
HIGH CUT

20.0 Hz–12.5 kHz, FLAT

 Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the high cut filter has no effect.
LOW DAMP -50–0–+50 Adjusts the amount of attenuation for the low frequency region.
HIGH DAMP -50–0–+50 Adjusts the amount of attenuation for the high frequency region.
MOD RATE 0–100 Adjusts the speed at which the reverb sound is modulated.
MOD DEPTH 0–100 Adjusts the depth to which the reverb sound is modulated.
DUCK SENS 0–100 Adjusts the sensitivity by which the volume is automatically adjusted according to the input. Increasing this value makes the response more sensitive at lower volumes.
DUCK PRE 0–100 When the input sound is loud, this automatically reduces the volume that is being “input” to the reverb and delay. As this setting approaches 100, the output volume reduction is applied more deeply.
DUCK POST 0–100 When the input sound is loud, this automatically reduces the volume that is being “output” from the reverb and delay. As this setting approaches 100, the output volume reduction is applied more deeply.
DIRECT LEVEL 0–100 Adjusts the volume of the direct sound.
CARRYOVER OFF, ON Sets whether to make the sound of the effect carry over or not after you turn it off.