Chain Palette

Delay with pitch-shifted sound mixed in.

Parameter Value Explanation
ON/OFF OFF, ON Turns this effect on/off.
TIME 1 ms–2000 ms, BPM ŀ–Ō

Adjusts the delay time.

  • When set to BPM, the value of each parameter will be set according to the value of the “MASTER BPM” specified for each memory. This makes it easier to achieve effect sound settings that match the tempo of the song.
  • If, due to the tempo, the time is longer than the range of allowable settings, it is then synchronized to a period either 1/2 or 1/4 of that time.
FEEDBACK 0–100 Adjusts the volume of delay that is returned to the input. Higher values increase the number of delay repeats.
EFFECT LEVEL 0–120 Adjusts the volume of the delay sound.
DIRECT LEVEL 0–100 Adjusts the volume of the direct sound.
HIGH CUT

20.0 Hz–12.5 kHz, FLAT

 Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the high cut filter has no effect.
MOD RATE 0–100 Adjusts the modulation rate of the delay sound.
MOD DEPTH 0–100 Adjusts the modulation depth of the delay sound.
DUCK SENS 0–100 Adjusts the sensitivity by which the volume is automatically adjusted according to the input. Increasing this value makes the response more sensitive at lower volumes.
DUCK PRE 0–100 The volume being “input” to the delay is automatically reduced when the input sound is loud. As this setting approaches 100, the output volume reduction is applied more deeply.
DUCK POST 0–100 The volume being “output” to the delay is automatically reduced when the input sound is loud. As this setting approaches 100, the output volume reduction is applied more deeply.
PITCH -24–+24 Lets you freely specify the amount of pitch shift for the delay.
PITCH BALANCE 0–100 Adjusts the balance between the pitch-shifted sound that is input to the delay and the direct sound.
PITCH FEEDBACK 0–100 Adjusts the amount of feedback for the delay that is applied to the direct sound.
CARRYOVER OFF, ON Sets whether to make the sound of the effect carry over or not after you turn it off.
BPM 40–250

Adjusts the BPM value for each memory.

  • BPM (beats per minute) indicates the number of quarter note beats that occur each minute.
  • When you have an external MIDI device connected, the MASTER BPM synchronizes to the external MIDI devices tempo, making it impossible to set the MASTER BPM. To enable setting of the MASTER BPM, set “SYNC CLOCK” to “INTERNAL”.