Chain Palette

A flanger that you can set in greater detail than the standard flanger effect.

Parameter Value Explanation
ON/OFF OFF, ON Turns this effect on/off.
RATE 0–100, BPM ŀ–Ō

Sets the rate of the flanging effect.

  • When set to BPM, the value of each parameter will be set according to the value of the “MASTER BPM” specified for each memory. This makes it easier to achieve effect sound settings that match the tempo of the song.
  • If, due to the tempo, the time is longer than the range of allowable settings, it is then synchronized to a period either 1/2 or 1/4 of that time.
DEPTH 0–100 Determines the depth of the flanging effect.
RESONANCE 0–100 Determines the amount of resonance (feedback). Increasing the value emphasizes the effect, for a more unusual sound.
MANUAL 0–100 Adjusts the center frequency at which to apply the effect.
WAVEFORM TRI, SINE Selects the type of wave.
SEPARATION 0, 15, 30, 45, 60, 75, 90, 105, 120, 135, 150, 165, 180 Adjusts the diffusion. The diffusion increases as the value increases.
STEP RATE OFF, 0–100, BPM ŀ–Ō This sets the cycle of the step function that changes the rate and depth. When it is set to a higher value, the change will be finer. Set this to “0” when not using the Step function.
TURBO OFF, ON If this is “ON,” a more intense effect is produced.
LOW DAMP -100–0 Adjusts the amount of feedback for the low-frequency region.
HIGH DAMP -100–0 Adjusts the amount of feedback for the high-frequency region.
LOW CUT FLAT, 20.0 Hz–12.5 kHz Sets the frequency at which the low cut filter begins to take effect. When “FLAT” is selected, the low cut filter has no effect.
HIGH CUT 20.0 Hz–12.5 kHz, FLAT Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the high cut filter has no effect.
EFFECT LEVEL 0–100 Adjusts the volume of the flanger.
DIRECT MIX 0–100 Adjusts the volume of the direct sound.
BPM 40–250

Adjusts the BPM value for each memory.

  • BPM (beats per minute) indicates the number of quarter note beats that occur each minute.
  • When you have an external MIDI device connected, the MASTER BPM synchronizes to the external MIDI devices tempo, making it impossible to set the MASTER BPM. To enable setting of the MASTER BPM, set “SYNC CLOCK” to “INTERNAL”.