Chain Palette

Gives a mild analog delay sound.

Parameter Value Explanation
ON/OFF OFF, ON Turns this effect on/off.
TYPE

MONO

 This is a simple mono delay.

DIR/EFX

 This is a stereo-in/out delay.
TIME 12 ms–1200 ms, BPM ŀ–Ō

Adjusts the delay time.

  • When set to BPM, the value of each parameter will be set according to the value of the “MASTER BPM” specified for each memory. This makes it easier to achieve effect sound settings that match the tempo of the song.
  • If, due to the tempo, the time is longer than the range of allowable settings, it is then synchronized to a period either 1/2 or 1/4 of that time.
FEEDBACK 0–100 Adjusts the volume of delay that is returned to the input. Higher values increase the number of delay repeats.
EFFECT LEVEL 0–120 Adjusts the volume of the delay sound.
DIRECT LEVEL 0–120 Adjusts the volume of the direct sound.
HIGH CUT

20.0 Hz–12.5 kHz, FLAT

 Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the high cut filter has no effect.
MOD RATE 0–100 Adjusts the modulation rate of the delay sound.
MOD DEPTH 0–100 Adjusts the modulation depth of the delay sound.
DUCK SENS 0–100 Adjusts the sensitivity by which the volume is automatically adjusted according to the input. Increasing this value makes the response more sensitive at lower volumes.
DUCK PRE 0–100 The volume being “input” to the delay is automatically reduced when the input sound is loud. As this setting approaches 100, the output volume reduction is applied more deeply.
CARRYOVER OFF, ON Sets whether to make the sound of the effect carry over or not after you turn it off.
DUCK POST 0–100 The volume being “output” to the delay is automatically reduced when the input sound is loud. As this setting approaches 100, the output volume reduction is applied more deeply.
CARRYOVER OFF, ON Sets whether to make the sound of the effect carry over or not after you turn it off.
BPM 40–250

Adjusts the BPM value for each memory.

  • BPM (beats per minute) indicates the number of quarter note beats that occur each minute.
  • When you have an external MIDI device connected, the MASTER BPM synchronizes to the external MIDI devices tempo, making it impossible to set the MASTER BPM. To enable setting of the MASTER BPM, set “SYNC CLOCK” to “INTERNAL”.