Parameter

Controllers

Value

Explanation

Carrier/Modulator Waveform

[2] knob (on the top screen only)

SINE, TRI, SQR, SAW

This sets the waveform.

Coarse Tune

PITCH

-24–+24

Specifies the pitch in semitone steps (maximum ±2 octaves).

Fine Tune

SHIFT+PITCH

-50–+50

Specifies the pitch in cents (maximum ±50 cents).

Ratio

TIMBRE

1.0–16.0

Sets the frequency ratio between the carrier and modulator.

Ratio Fine

SHIFT+TIMBRE

-50–+50

Sets the frequency ratio between the carrier and modulator in smaller steps.

Mod Env Atk

 [OSC 1] slider

0–1023

Sets the attack time of the modulation envelope.

Mod Env Dcy/Rel

 [OSC 2] slider

0–1023

Sets the decay and release times of the modulation envelope.

Mod Env Sus

 [OSC 3] slider

0–511

Sets the sustain level of the modulation envelope.

Mod Depth

 [OSC 4] slider

0–63

Sets the intensity of the modulation envelope.
Larger values produce a greater change with the modulation envelope.

Carrier/Modulator Pulse Width

-

0–63

This effect changes the duty ratio of the pulse width to alter the waveform.
You can use this effect with other waveforms besides SQR (square wave).

  • A value of zero results in a 50:50% duty ratio.

Carrier/Modulator PWM Depth

-

0–63

Sets how much the LFO is applied (depth) to the PW (pulse width).
The pulse width is modulated according to the LFO settings.

Carrier/Modulator Fat

-

0–63

Distorts the waveform and adds a frequency component one octave lower than the original waveform.