Parameter

Value

Explanation
Drive Switch OFF, ON Turns overdrive/distortion on/off
D. Type OVERDRIVE, DISTORTION Type of distortion
Drive 0–127

Degree of distortion

Also changes the volume.
Tone 0–127 Sound quality of the Overdrive effect
Amp Switch OFF, ON Turns the Amp Simulator on/off.

AmpType

SMALL, BUILT-IN, 2-STACK, 3-STACK

Type of guitar amp

SMALL: Small amp
BUILT-IN: Single-unit type amp
2-STACK: Large double stack amp
3-STACK: Large triple stack amp

TWah Switch

OFF, ON

Wah on/off

TWah Mode

LPF, BPF

Filter type

LPF: The wah effect will be applied over a wide frequency range.
BPF: The wah effect will be applied over a narrow frequency range.

TWah Polar

DOWN, UP

Direction in which the filter will move

DOWN: The filter will change toward a lower frequency.
UP: The filter will change toward a higher frequency.
TWah Sens 0–127 Sensitivity with which the filter is modified
TWah Manual 0–127 Center frequency at which the wah effect is applied

TWah Peak

0–127

Width of the frequency region at which the wah effect is applied

Increasing this value will make the frequency region narrower.
TWah Bal D100: 0W–D0: 100W Adjusts the volume balance between the sound that is sent through the wah (W) and the sound that is not sent through the wah (D).
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Level 0–127 Output Level