Turn the [1] knob or press the [OSC 1]–[OSC 4] buttons to select an oscillator, and use the [2] knob to select the oscillator waveform.
Use the [OSC 1]–[OSC 4] sliders to set the volume for each oscillator.

Parameter

Controllers

Value

Explanation

Osc 1–4 Waveform

[2] knob (on the top screen only)

This sets the waveform.

SAW

Sawtooth wave

SQR

Square wave

TRI

Triangle wave

SINE

Sine wave

RAMP

Ramp wave

JUNO

Modulated sawtooth wave

TRI2

Triangle wave variation

TRI3

Triangle wave variation

SINE2

Sine wave variation

SSAW

SuperSAW

NOISE

White noise

Osc 1–4 Coarse Tune

PITCH

-24–+24

Specifies the pitch in semitone steps (maximum ±2 octaves).

Osc 1–4 Fine Tune

SHIFT+PITCH

-50–+50

Specifies the pitch in cents (maximum ±50 cents).

Osc 1–4 PWM Depth

TIMBRE

0–63

Sets how much the LFO is applied (depth) to the PW (pulse width). The pulse width is modulated according to the LFO settings.

Osc 1–4 Pulse Width

SHIFT+TIMBRE

0–63

This effect changes the duty ratio of the pulse width to alter the waveform.
You can use this effect with other waveforms besides SQR (square wave).

  • A value of zero results in a 50:50% duty ratio.

Osc 1 Level

[OSC 1] slider

0–127

Sets the volume of OSC 1.

Osc 2 Level

[OSC 2] slider

0–127

Sets the volume of OSC 2.

Osc 3 Level

[OSC 3] slider

0–127

Sets the volume of OSC 3.

Osc 4 Level

[OSC 4] slider

0–127

Sets the volume of OSC 4.

Osc 1–4 Fat

–

0–63

Distorts the waveform and adds a frequency component one octave lower than the original waveform.

Osc 1-2, 3-4 Sync

–

OFF, SYNC

Implements the oscillator sync function that is provided by an analog synthesizer.

The OSC 1 or 2 is reset at intervals of the OSC 3 or 4’s pitch cycle.

Osc 1–4 SSaw Detune

–

0–127

Adjusts how much the SuperSAW is detuned. Larger values create a greater detune effect.

  • This is enabled only when “SSAW” is selected for the waveform.

Osc 1–4 LED Color

–

RED, ORANGE, YELLOW, GREEN, BLUE, PURPLE, PINK, WHITE, SKYBLUE, P.YELLOW, P.BLUE, P.PINK, L.RED, L.ORANGE, L.YELLOW, L.GREEN, P.GREEN, L.SKYBLUE, L.BLUE, L.PURPLE

Sets the oscillator section LED color for each oscillator.