Isolator

This is an equalizer which cuts the volume greatly, allowing you to add a special effect to the sound by cutting the volume in varying ranges.

Parameter	Value	Explanation
Low Level	-60–+4 [dB]	These boost and cut each of the High, Middle, and Low frequency ranges. At -60 dB, the sound becomes inaudible. 0 dB is equivalent to the input level of the sound.
Mid Level	-60–+4 [dB]
High Level	-60–+4 [dB]
Low AP Sw	OFF, ON	Turns the Anti-Phase function on and off for the Low frequency ranges. When turned on, the counter-channel of stereo sound is inverted and added to the signal.
Low AP Lv	0–127	Adjusts the level settings for the Low frequency ranges. Adjusting this level for certain frequencies allows you to lend emphasis to specific parts (This is effective only for stereo source.).
Mid AP Sw	OFF, ON	Settings of the Anti-Phase function for the Middle frequency ranges. The parameters are the same as for the Low frequency ranges.
Mid AP Lv	0–127
Boost Sw	OFF, ON	Turns Low Booster on/off. This emphasizes the bottom to create a heavy bass sound.
Boost Lv	0–127	Increasing this value gives you a heavier low end. Depending on the Isolator and filter settings this effect may be hard to distinguish.
Level	0–127	Output Level