This is a variety of saturator, and is distinctive for its warmer sound.
Parameter |
Value |
Explanation |
|---|---|---|
LowFreq |
20–16000 [Hz] |
Input filter (low range) Boosts/cuts the sound below the specified frequency. |
LowGain |
-24.0–+24.0 [dB] |
Input filter (low range) Amount of boost/cut |
Hi Slope |
THRU, -12dB, -24dB |
Amount of attenuation per octave THRU: No attenuation |
Hi Freq |
20–16000 [Hz] |
Input filter (high range) Boosts/cuts the sound above the specified frequency. |
Pre1 Type |
THRU, LPF, HPF, LSV, HSV |
Types of filter that precedes the distortion processing THRU: No filter is applied |
Pre1Freq |
20–16000 [Hz] | Frequency at which the pre-distortion filter operates |
Pre1Gain |
-24.0–+24.0 [dB] | For the LSV/HSV types, the amount of boost/cut |
Drive |
0.0–48.0 [dB] | Strength of distortion |
Post1 Type |
THRU, LPF, HPF, LSV, HSV | Type of filter 1 which follows the distortion processing |
Post1Frq |
20–16000 [Hz] | Frequency at which post-distortion filter 1 operates |
Post1Gain |
-24.0–+24.0 [dB] | For the LSV/HSV types, the amount of boost/cut |
Post2 Type |
THRU, LPF, HPF, LSV, HSV | Type of filter 2 which follows the distortion processing |
Post2Frq |
20–16000 [Hz] | Frequency at which post-distortion filter 2 operates |
Post2Gain |
-24.0–+24.0 [dB] | For the LSV/HSV types, the amount of boost/cut |
Post3 Type |
THRU, LPF, HPF, BPF, PKG |
Type of filter 3 which follows the distortion processing THRU: No filter is applied |
| Post3Frq | 20–16000 [Hz] | Frequency at which post-distortion filter 3 operates |
| Post3Gain | -24.0–+24.0 [dB] | For the PKG type, the amount of boost/cut |
| Post3 Q | 0.5–16.0 | Width of the frequency range affected by the filter |
| Sense | -60.0–0.0 [dB] | Adjust this value so that the sound is not made louder when distortion is applied. |
| PostGain | -48.0–+12.0 [dB] | Gain following distortion processing |
| Balance | D100: 0W–D0: 100W | Volume balance between the dry sound (D) and effect sound (W) |
| Level | 0–127 | Output Level |