Slicer

By applying successive cuts to the sound, this effect turns a conventional sound into a sound that appears to be played as a backing phrase.
This is especially effective when applied to sustain-type sounds.

Parameter	Value	Explanation
Step 1–16	0–127	Level at each step
Rate Sync	OFF, ON	If this is ON, the rate synchronizes with the tempo of the rhythm. Tempo (Pattern) Tempo (System)
Rate	0.05–10.00 [Hz]	Rate at which the 16-step sequence will cycle
Rate Note	Note	Rate at which the 16-step sequence will cycle
Attack	0–127	Speed at which the level changes between steps
In Sync Sw	OFF, ON	Specifies whether an input note will cause the sequence to resume from the first step of the sequence (ON) or not (OFF)
InSyncThres	0–127	Volume at which an input note will be detected
Mode	LEGATO, SLASH	Sets the manner in which the volume changes as one step progresses to the next. LEGATO: The change in volume from one step’s level to the next remains unaltered. If the level of a following step is the same as the one preceding it, there is no change in volume. SLASH: The level is momentarily set to 0 before progressing to the level of the next step. This change in volume occurs even if the level of the following step is the same as the preceding step.
Shuffle	0–127	Timing of volume changes in levels for even-numbered steps (step 2, step 4, step 6...). The higher the value, the later the beat progresses.
Level	0–127	Output Level