SuperFilter

This is a filter with an extremely sharp slope. The cutoff frequency can be varied cyclically.

Parameter	Value	Explanation
Type	LPF, BPF, HPF, NOTCH	Frequency range that will pass through each filter LPF: Frequencies below the cutoff BPF: Frequencies in the region of the cutoff HPF: Frequencies above the cutoff NOTCH: Frequencies other than the region of the cutoff
Slope	-12, -24, -36 [dB]	Amount of attenuation per octave -12 dB: Gentle -24 dB: Steep -36 dB: Extremely steep
Cutoff	0–127	Cutoff frequency of the filter Increasing this value will raise the cutoff frequency.
Resonance	0–100	Filter resonance level Increasing this value will emphasize the region near the cutoff frequency.
Gain	0–+12 [dB]	Amount of boost for the filter output
Mod Sw	OFF, ON	On/off switch for cyclic change
Mod Wave	TRI, SQR, SIN, SAW1, SAW2	How the cutoff frequency will be modulated TRI: Triangle wave SQR: Square wave SIN: Sine wave SAW1: Sawtooth wave (upward) SAW2: Sawtooth wave (downward)
Rate Sync	OFF, ON	If this is ON, the rate synchronizes with the tempo of the rhythm. Tempo (Pattern) Tempo (System)
Rate	0.05–10.00 [Hz]	Frequency of modulation
Rate Note	Note	Frequency of modulation
Depth	0–127	Depth of modulation
Attack	0–127	Speed at which the cutoff frequency will change This is effective if Mod Wave is SQR, SAW1, or SAW2.
Level	0–127	Output Level