Parameter

Value

Explanation
Drive Switch OFF, ON Turns overdrive/distortion on/off
D. Type OVERDRIVE, DISTORTION Type of distortion

Drive

0–127

Degree of distortion
Also changes the volume.

Tone

0–127

Sound quality of the Overdrive effect

Amp Switch

OFF, ON

Turns the Amp Simulator on/off.

AmpType

SMALL, BUILT-IN, 2-STACK, 3-STACK

Type of guitar amp

SMALL: Small amp
BUILT-IN: Single-unit type amp
2-STACK: Large double stack amp
3-STACK: Large triple stack amp

AWah Switch

OFF, ON

Wah on/off

AWah Mode

LPF, BPF

Filter type

LPF: The wah effect will be applied over a wide frequency range.
BPF: The wah effect will be applied over a narrow frequency range.

AWah Manual

0–127

Center frequency at which the wah effect is applied

AWah Peak

0–127

Width of the frequency region at which the wah effect is applied

Increasing this value will make the frequency region narrower.

AWah Sync

OFF, ON

If this is ON, the rate synchronizes with the tempo of the rhythm.

Tempo (Pattern)

Tempo (System)

AWRate

0.05–10.00 [Hz]

Frequency of modulation

AWRate Nt

Note

AWah Depth

0–127

Depth at which the wah effect is modulated
AWah Bal D100: 0W–D0: 100W Adjusts the volume balance between the sound that is sent through the wah (W) and the sound that is not sent through the wah (D).
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Level 0–127 Output Level