On the OUTPUT ASSIGN screen, press the [F1]–[F5] buttons to select the parameters to configure.
The parameters are the same as those that are set in the OUTPUT/EFFECTS screen. On this OUTPUT ASSIGN screen, you can check the parameters as a list.
PAD OUT (PAD OUTPUT)
Specifies the output destination for the pad audio.
Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
EFFECT OUT (EFFECT OUTPUT)
Sets the output destination for audio from MFX 1-4 and from the side chain compressor.
Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
PAD DIR (PAD DIRECT)
Set this when you want to output the pad sounds to DIRECT OUT.
Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
EFFECT DIR (EFFECT DIRECT)
Set this when you want to output the MFX 1-4 and side chain compressor audio to DIRECT OUT.
Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
SC CTRL (SIDE CHAIN CTRL)
Turn this on when using the pad sounds as the side chain control signal.
Select the pad to trigger to set using the cursor [ã] [â] buttons, and use the [-] [+] buttons to turn this off/on.
Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.