Step Flanger

This is a flanger in which the flanger pitch changes in steps.
The speed at which the pitch changes can also be specified in terms of a note-value of a specified tempo.

Parameter	Value	Explanation
Filter Type	OFF, LPF, HPF	Type of filter OFF: No filter is used. LPF: Cuts the frequency range above the Cutoff Freq HPF: Cuts the frequency range below the Cutoff Freq
Cutoff Freq	200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 [Hz]	Basic frequency of the filter
Pre Delay	0.0–100.0 [msec]	Adjusts the delay time from the direct sound until the flanger sound is heard.
Rate (sync sw)	OFF, ON	If this is ON, the rate synchronizes with the tempo of the rhythm. Ø KIT TEMPO
Rate (Hz)	0.05–10.00 [Hz]	Frequency of modulation
Rate (note)	Note Ø Note	Frequency of modulation
Depth (*1)	0–127	Depth of modulation
Phase	0–180 [deg]	Spatial spread of the sound
Feedback	-98–+98 [%]	Adjusts the proportion of the flanger sound that is fed back into the effect. Negative (-) settings will invert the phase.
Step ()	OFF, ON	If this is ON, the rate synchronizes with the tempo of the rhythm.
Step Rate (Hz)	0.10–20.00 [Hz]	Rate (period) of pitch change
Step Rate (note)	Note Ø Note	Rate (period) of pitch change
Low Gain	-15–+15 [dB]	Gain of the low range
High Gain	-15–+15 [dB]	Gain of the high range
Balance	D100:0W–D0:100W	Volume balance between the direct sound (D) and the flanger sound (W)
Level	0–127	Output Level

*1: This parameter corresponds to MFX Ctrl. For details, refer to “Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX Ctrl)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “Controlling the MASTER EFFECT with the MASTER EFFECT Knob (MASTER EFFECT CTRL)”.