Use an all-purpose clamp (APC-33, sold separately) or a pad stand (PDS-20/PDS-10, sold separately) when mounting the SPD-SX PRO onto a stand.
  • Be sure to use the screw found on the bottom of the SPD-SX PRO. If you use different screws, the unit may malfunction.
  • Before turning the unit over, lay out several pieces of newspaper or magazines at the four corners and on both sides of this unit to protect the buttons, knobs and other controls from damage. When doing so, make sure to place the unit so that the buttons, knobs and other controls do not get damaged.
  • When turning the unit over, handle it carefully so as not to drop or overturn it.
  • Do not store this unit upside down. The floor or other surface may press against the pads, squashing the pad sensors and causing them to malfunction.


Using in combination with a drum set

To use this unit with V-Drums or a drum set by mounting it onto a stand or the likes, use the all-purpose clamp (APC-33, sold separately) to hold the unit in place.
Use the screws on the bottom of the SPD-SX PRO to mount it onto the stand holder of the all-purpose clamp, as shown in the illustration. Attach the SPD-SX PRO to the all-purpose clamp.

  • Don’t use the screws that are included with the all-purpose clamp.


  • Rods within a 10.5–30 mm diameter can be mounted on the all-purpose clamp.



Using this unit separately

To use the SPD-SX PRO separately, use the pad stand (PDS-20/PDS-10, sold separately).
Use the screws on the bottom of the SPD-SX PRO to mount it onto the stand holder of the PDS-20/PDS-10, as shown in the illustration. Next, mount the SPD-SX PRO onto the pad stand.
See the Owner’s Manual of the pad stand for how to assemble the pad stand or for how to attach the stand holder.

  • Don’t use the screws that are included with the pad stand.


Setup Examples